Dented Panels
Hail dents the ribs and flats of metal panels. Cosmetic dents stay; dents that break a seal get repaired. Any dent at a lap or a screw gets a closer look.
Commercial roof repair in Hereford for metal barns and equipment buildings after hail and wind, with the damage documented before anything is fixed.


Metal barns and equipment buildings on open land around Hereford take hail with nothing around them to break it. Dents alone rarely leak; the trouble is cracked washers at dented screws, broken skylight panels, and laps knocked open.
We photograph the damage first, so you have a record for your insurer before any repair changes what the roof shows. Wind does its own damage at the same time, lifting trim and laps along the roof edges.
Open-land buildings show storm damage in a few predictable places.
Hail dents the ribs and flats of metal panels. Cosmetic dents stay; dents that break a seal get repaired. Any dent at a lap or a screw gets a closer look.
A dent near a screw can crack its rubber washer, leaving a small hole that leaks in the next rain. One cracked washer can wet the insulation under a whole panel.
Translucent panels crack or shatter under hail and let rain straight in. Shards are removed and the opening is covered until the new panel arrives.
Spring wind and storm gusts lift ridge caps, rake trim, and lap edges along the roof perimeter. Loose trim is refastened into solid framing with new screws.
Strong storms strip leaves and branches onto the roof, and the gutters fill and overflow under the next rain. Downspouts are checked for blockage at the same time.
Chipped coating at hail marks on panels and trim exposes bare steel, which starts to rust within a season. Treating those spots early keeps them from becoming holes.
Hail damage usually stays hidden until the next rain finds it.
Photos taken before repair show the roof damage as it was, which is what insurers ask for. Dated photos match the storm to the damage.
Replacing cracked washers near dents stops leaks that would otherwise show up one storm later. Those small holes often wet the insulation before anyone notices.
Tractors, tools, and stored goods under a broken skylight stay out of the rain once it is replaced. Stored feed, tools, and parts stay out of the rain too.
Refastened trim and closures hold in the next round of spring wind. Lifted trim left alone tends to peel back farther with each gust.
Hereford storm work falls under these two services.

Screws, washers, laps, trim, and skylight panels on the metal barns and equipment buildings around Hereford. Gutters filled by storm debris are cleared and resealed too.
Commercial metal roof repair
When rain finds its way in after a storm, leak tracing locates the damaged detail behind the drip. Every stain is traced and photographed for your insurance record.
Commercial roof leak repairTake photos before anything is moved or patched, then call your insurer and us. We will document the roof on the first visit.
Four steps, with documentation built into the first one.


The roof is walked and every dent, cracked washer, broken skylight, and lifted trim piece is photographed with the storm date before repairs start. Hail size and storm date go on every photo sheet.
Inside, drips and wet spots are matched to the damaged panels above. Hail damage can leak in several places at once. Wet insulation under broken skylights is checked too.
Cracked washers get new screws, broken skylight panels are replaced to match, and lifted trim and laps are refastened and sealed. Dented panels with intact seals are left as they are.
Repaired areas get a hose test, and after-repair photos join the storm photos in one record for your insurer. The record shows each repair next to its storm photo.
Hereford sits southeast of Sierra Vista along SR 92. Its unit is highlighted on the map.
Rooftop units on off-post businesses, under town permits.
Long metal storage rows where eaves carry the runoff.
Historic storefronts; visible repairs wait on commission review.
Wide warehouse roofs along the rail line and I-10.
Shops on SR 92 with aging skylight panels.
Start before anything is cleaned up or repaired. Arizona's Department of Insurance and Financial Institutions advises photos and video first, a call to your insurer before temporary repairs, and keeping every receipt. Record the storm date, stains, wet stock, and roof photos of dents and torn seams.
Hereford is unincorporated, so Cochise County Building Safety handles commercial permits. Its minor-work exemptions leave out commercial projects, so check before larger repairs.
No. Many dents are cosmetic. Leaks come from cracked washers near dents, broken skylight panels, and laps knocked open, which is why each of those gets checked. A roofer can tell the two apart on the first walk.
Look from the ground or a ladder for lifted trim, broken skylights, and debris around gutters. Leave walking the roof to a roofer, since dented panels and broken skylights are hazards. Photos from the ground still help the roofer plan the visit.
Usually, yes. Replacement translucent panels come in the common rib profiles, and the panel is fastened and sealed along both laps.
Ask your insurer first. Temporary repairs to stop water are often fine once photos exist, and permanent repairs follow whatever the insurer requires.
Leave anything large in place until photos are taken, then clear gutters and drains so the next rain drains off. Broken skylight pieces should be removed by a roofer.
As soon as it is safe, and before the next rain. Cracked washers and broken skylights leak right away, and photos are clearer before debris shifts.
Send the address, the storm date, and photos if you have them.
Leave your name and number and we will call you to talk through the leak or damage.
Rather talk now? Call (623) 310-0177